Loads need to be lifted and moved in almost all industries all over the world. For example, on construction sites, at transshipment
stations, in warehouses and in assembly and production halls.
stations, in warehouses and in assembly and production halls.
These loads are lifted and moved by tower and gantry cranes, trolley traveling winches, hoists and trolleys. The drives on
this machinery must be operated either manually (ground-controlled) or remotely (radio-controlled). It goes without saying
that required safety instruments such as load recognition and limit switch controls must also be installed.
this machinery must be operated either manually (ground-controlled) or remotely (radio-controlled). It goes without saying
that required safety instruments such as load recognition and limit switch controls must also be installed.
A typical crane control application is the gantry crane. In this case, crane control can be used not only for the travel axes
but also for the hoist axis. The travel distance on both travel axes must be limited with a limit switch. In addition to limit
switches, speed reduction switches are normally installed to reduce the speed towards the end of the stretch. For safety reasons,
limit switches must also be monitored. Load-controlled speed reduction optimizes utilization of the power installed on the
hoist axis.
but also for the hoist axis. The travel distance on both travel axes must be limited with a limit switch. In addition to limit
switches, speed reduction switches are normally installed to reduce the speed towards the end of the stretch. For safety reasons,
limit switches must also be monitored. Load-controlled speed reduction optimizes utilization of the power installed on the
hoist axis.
The drive solution with MOVIDRIVE® is based on the “Crane Control” application module. The “Crane Control” application module is part of the MOVITOOLS® MotionStudio software for MOVIDRIVE® and can be accessed as soon as the license is purchased. The user-friendly interface guides you through the process of setting
the parameters. Only those parameters required for the specific application, such as fixed setpoints, ramps and speed, must
be entered.
the parameters. Only those parameters required for the specific application, such as fixed setpoints, ramps and speed, must
be entered.
The application module uses this information to create the control program and loads it into the inverter. MOVIDRIVE® then takes over the entire motion control. Users can also opt to control the inverter with variable speed selection or by
fixed setpoints.
fixed setpoints.
No matter how large the variety of applications for crane control, the wide range of functions provided by the application
module provides the right solution for every task.
module provides the right solution for every task.
- 6 fixed setpoints for multi-stage switching
- Variable speed in motor potentiometer mode.
- Switchover option between fixed setpoints and variable speed regulation during operation.
- Speed reduction and limit switches are monitored.
- Speed is reduced when the speed reduction switches are reached.
One of the main MOVIDRIVE® features used in the application modules is IPOSplus® positioning and sequence control. Based on the specifications, an IPOSplus® program in MOVIDRIVE® controls the entire motion sequence with the application module as machine-oriented as possible.
In addition to gantry cranes, the “Crane Control” application module can be used for further applications. Examples are:
- Construction cranes
- Manually operated floor conveyor vehicles with limit switch monitoring
- Wide range of functions
- User-friendly user interface
- You only have to enter the parameters needed for the application
- Guided parameter setting process instead of complicated programming
- No programming experience required
- Rapid familiarization with the system
- Choice of ground or radio control
- Movement control is carried out completely by the IPOSplus® program in MOVIDRIVE®
- Limit switch control and load recognition
| back to top |
